« 12 Seconds of Sunrise | Main | Your Social Identity. Remember to be the Master of your own Domain. »
August 15, 2008
Weekend Project: Get to know 5 of your Facebook “Friends”
For those of you looking for something to do this weekend, here is something you can do without leaving the comfort of your wifi connectivity...Get to know 5 of your Facebook Friends.
The next time you log into Facebook, take a look at your friends list. If there are people on your friends list who you don’t know that well, assuming there was a reason why you said yes to adding them as a friend, now is a great time to make the effort and get to know these people.
The 5 Friends Weekend Project:
- Identify 5 people from your friends list who you want to get to know better.
- Visit their profiles
- Send each of them a short message that relates to something you learned about them in their profile.If you really want to get to know them, make it a video message.
- If you don’t hear back from someone before the end of the weekend, feel free to remove them from your friend’s list. (and if they respond after your removed them from your friends list, well, you can always add them back.)
- Enjoy the conversations with the people who you reached out to.
---
So take a few minutes, identity five people from your friends list who you would like to know better, write down their names, visit their profiles and get started. And who knows, you might have a new friend or two by the end of the weekend.
Tags: facebook, Social Media, Jeff Pulver
Posted by jeff on August 15, 2008 07:05 PM | Permalink
Additional resources: #140conf events | Watch the Jeff Pulver Show | Jeff's Qik Videos
Comments
Find a stated accuracy for your thermometers, make a copy of the page and retain that documentation. I think it important to have a document on file as to what their [http://www.thermometermanufacturer.cn/html/en/pressure_gauge_thermometer.html Pressure Gauge Manufacturer] stated accuracy is (I will respond to your comment about creating your own specs later in my reply).
As for the certificate from the contractor.Thermometer Manufacturer I have been a lab supervisor as a contractor doing calibrations. As far[http://www.thermometermanufacturer.cn/html/en/pressure_gauge_thermometer.html Thermometer Manufacturer] as I am concerned, they MUST state in their documentation Pressure Gauge Manufacturer what the tolerance limits that they calibrated your thermometers to. It may be that you have to pay extra to receive that documentation. But it is a must. My preference (and implicit in some standard t[http://www.papercuttingmachine.cn/ paper cutting machine]hermowell requirements) is to have any or all cals done with BEFORE/AFTER data (in this case, only AFTER, as you cannot adjust liquid-in-glass thermometers). On the data sheet must be stated what measurement points are [http://www.bagmakingmachine.net.cn/ 制袋机] tested by the contractor, and must list the upper and lower tolerance limits. In order forpaper cutting machine a calibration (in this case, only a verification) to be valid, you must be checking to see if your thermometers are measuring within a specified set of tolerance limits. The contractor then must beijing escortuse standards that meet acceptable limits of uncertainty (for example a drywell(dryblock) calibrator, or other).
Posted by: youbo at January 10, 2010 07:00 AM
Great post.Thanks a lot.
Posted by: dış cephe at November 30, 2009 04:43 AM
There are so many factors as to why someone may not answer you at all. Some messages don't really require a response. Sometimes silence is the nicest response, because it means you don't have to respond to their response. With my closest friends, we dont' need to communicate very much ---- we understand each other in the unspoken.
Posted by: Mimi at August 16, 2008 11:34 AM
Aren't you afraid that you will get an awful lot of messages this way :-)
Posted by: Søren Larsen at August 15, 2008 07:08 PM